Ibm RS/6000 Manual do Utilizador descarregar pdf (Página 135)

It does not matter. You should use this procedure just to make sure that the

selected adapter parameter is correct.

9. If the Bus I/O Address is in conflict with the parameter setting for another ISA

adapter already installed, the following message will be displayed:

sa3 Defined

lsresource : The attribute(s) for some device(s) in the system

could not be resolved. To resolve conflicts, attribute(s) need to be

modified. A suggested value for each attribute is provided.

DEVICE ATTRIBUTE CURRENT SUGGESTED DESCRIPTION

--------------- --------------- --------- --------- -----------

sa3 bus_io_addr x324 x34 Connection address

Method error (/usr/lib/methods/cfgcxma):

514-4 Error initializing a device into the kernel.

sa3 deleted

Change the parameter value as suggested by the lsresource command, and

press Enter.

10. Once no parameters conflicts are reported, you can set the DIP switches on

the adapter card as described in Table 17 on page 109 to reflect the selected

Bus I/O Address's correct value.

11. Shut down and power-off the system.

12. Install physically the adapter on an ISA slot.

13. Power-on and reboot the system.

14. Configure the adapter using the fastpath smit isa, and repeat the procedure

from step 5 to step 8.

15. Verify the results with the following command:

lsdev -Cc adapter -s isa

If the configuration was successful, the adapter will be available, and the

system will display information similar to the following:

sa3 Available 1-1 IBM 8-Port Async, EIA-232 (ISA)

16. Once the adapter status is Available, you may proceed to configure the serial

devices on its ports by using the smit devices fastpath.

6.5 128-Port EIA-232 Asynchronous ISA Adapter (FC 2933)

This section provides information needed for installing and configuring the 128-Port

Asynchronous ISA Adapter. This adapter can be ordered as an optional feature on

PCI-based RS/6000 servers.

The 128-Port Asynchronous ISA Adapter provides support for attaching a maximum

of 128 EIA-232D asynchronous serial devices (such as terminals, modems and

printers) to a system unit when used with one or more optional Remote

Asynchronous Nodes 16-Port EIA-232. It contains the following components:

Chapter 6. Adapter and Device Configuration on PCI-Based RS/6000 Servers 111

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 227 228

Sem comentários

Ibm RS/6000 Manual do Utilizador Página 135