IBM H80 Manual do Utilizador descarregar pdf (Página 105)

SCSI Utilities

SCSI Utilities allow you to set delay times for the SCSI hard disk spin-up and to set

SCSI IDs for SCSI controllers installed in the system.

à ð

SCSI Utilities

1. Harddrive Spin Up Delay

2. Change SCSI Id

.--------.

| X=Exit |

--------'

===>

Using the Harddrive Spin Up Delay option allows you to change the spin up delay

time for SCSI hard disk drives attached to your system. Spin up delay values can be

entered manually, or you can use a default setting (two seconds). All values are

measured in seconds.

Attention: Setting the value lower than the default can prevent successful booting

because the system power handling capabilities might be exceeded. If the system

no longer boots after setting this value, access this utility again and increase the

value. It is also possible that adding disk drives can cause similar symptoms.

Changing this value changes the surge current requirements on the system. As you

increase the value, the surge current requirements on the system are decreased.

Select Console

Select this option to define which display is used by the system for system

management. If no console is selected, the console defaults to Serial Port 1.

à ð

Press  to select this console

as the active console

Chapter 4. Using System Management Services 89

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 229 230

Sem comentários

IBM H80 Manual do Utilizador Página 105