Ibm B50 Manual do Utilizador descarregar pdf (Página 170)

Memory Modules

You can increase the amount of memory in your system by installing memory

modules. Your server uses 168-pin, 3.3 volt, dual inline Error Correcting Code

(ECC) memory modules (DIMMs) to increase system memory.

You install memory modules into connectors inside the server. You can install up to

1024MB of ECC memory. (1MB equals approximately 1 000 000 bytes.) The

memory module sizes for your system include 256MB, 128MB, 64MB, 32MB, and

16MB. The available speed for these memory modules is 60 ns.

Note: When you install memory modules, install the new modules into the first

available unused connector, starting at slot 4.

Removing Memory Modules

1. Locate the memory module connectors on the system board.

The memory module connectors are shown in the following figure.

2. Remove any adapters that are blocking the memory module connectors (see

“Adapter” on page 7-25).

3. Determine which memory modules you want to remove.

If you are replacing the memory modules you remove, they must be replaced

with the same type.

7-26 7046 Model B50 Service Guide

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 197 198

Sem comentários

Ibm B50 Manual do Utilizador Página 170